Re: 1954 Pacific disc brake conversion kit / the residual pressure valve must be removed

Posted by HH56 On 2020/8/25 13:53:56

If you have the manual master the residual valve assy just sits in the end of the cylinder held by the piston return spring as your illustration shows and can be removed by taking the master apart just as if you were doing a rebuild. If you have the Bendix power brake you need to remove the hydraulic output fitting to access the residual valve assy and then make sure the fitting seals again when it screws back in. You may need a new O ring for a proper seal.

Attach file:

---

  (40.43 KB)