Removing cage from Blower motor
Posted by Bob E. On 2020/6/23 22:57:33
Hi,
I need to rewire the motor as the current wiring has lost its insulation. The motor works. Any suggestions for how to remove the cage? I've put PB-blaster in the hole where the set screw goes as well as at the other end, pulled and(gently) pried. But it wont budge. I'm concerned about bending the cage or the shaft but the thing wont move.
Any idea as to how hard I can yank on it or other suggestions to remove (to expose wiring) without damage? thanks
Attach file:
(281.78 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=223785