A arm
Posted by R H On 2020/7/26 15:27:43
My tire is wearing on the inside. So which way would make the wheel lean up to center
Two ways to look at it. Which way to put that bump on shaft.
Or which which holes to use. Thin . wide.
The way shaft is now ..to me looks like that would move tire more center. It's pushing top if tire over center. Which would make tire run off the inside.
It is confusing.
Attach file:
(337.06 KB)
Two ways to look at it. Which way to put that bump on shaft.
Or which which holes to use. Thin . wide.
The way shaft is now ..to me looks like that would move tire more center. It's pushing top if tire over center. Which would make tire run off the inside.
It is confusing.
Attach file:
(337.06 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=225026