Re: A arm
Posted by R H On 2020/8/10 18:28:33
Ok.. To me that arm should be tighten down on the rebound rubber .
Pulling that arm down. To get it back together. Pulls the from end down.
The rear rides up going down the road. And at stops.
you want the front end loaded. So the front doesn't go down.
I tighten the bushings at level. And that's where the A arm is.
This is the pass. Side and easier to deal with.
I'm gonna loosen the bushings and tighten them in the air.
Attach file:
(315.27 KB)
Pulling that arm down. To get it back together. Pulls the from end down.
The rear rides up going down the road. And at stops.
you want the front end loaded. So the front doesn't go down.
I tighten the bushings at level. And that's where the A arm is.
This is the pass. Side and easier to deal with.
I'm gonna loosen the bushings and tighten them in the air.
Attach file:
(315.27 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=225471