Hi Guys and girls. I'm pulling down my ultramatic in my 56 Clipper. Firstly, in the pic below, i'm thinking this is my hi range clutch assembly but someone has welded it and i'm not quite sure why? Also when I went to bolt up my transmission (bellhousing to motor), it doesn't seem to matter how hard I try I cant get it all the way home. comes up about a half inch short and I cant get it flush to bolt it up. Any assistance would be greatly appreciated...
ultramatic.jpg (169.50 KB)
ultramatic.jpg (166.83 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=232256