Ross - Thanks for input. Changing a pin doesn’t look all that difficult with the tool and making a pin seems like an easy job on a lathe. I’m not sure my mini lathe is up to making the pin, but I’ll see if one of my friends has a larger one.
I checked the rubber bushings on the load arms and they appear to be OK (see pics). With the car level on the left side, both the front and rear of the bottom of the chrome strip were 10 + ¼” from the ground. On the right side of the car, the front was about 8” while the rear was 9”.
My current thought is to make and install a #4 pin.
Attach file:
Left.JPG (174.77 KB)
Right.JPG (182.92 KB)
Left Lower.JPG (186.45 KB)
Right Lower.JPG (216.33 KB)
Left Wheel.JPG (222.76 KB)
Right Wheel.JPG (226.76 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=237450