Re: Torsion Level System
Posted by Marty or Marston On 2021/10/8 18:58:33
I put the end pieces back in the #3 pin that I had removed and determined that a pin could only be another 3/8” to ½” longer and to be able to be inserted. Inspecting the Front Load Arm (FLA) shows that it points slightly down and not parallel with the ground (not sure what it should be).
I’ve examined the chain to ensure that nothing was hanging up with it and found there was plenty of clearance. I placed a piece of ½” threaded stock between the lower A arm and the FLA and using the nut on the threaded stock and tried to raise the FLA by turning the lower nut to no avail.
I'm at a loss, but open to suggestions or thoughts.
Attach file:
IMG_3398.JPG (185.25 KB)
I’ve examined the chain to ensure that nothing was hanging up with it and found there was plenty of clearance. I placed a piece of ½” threaded stock between the lower A arm and the FLA and using the nut on the threaded stock and tried to raise the FLA by turning the lower nut to no avail.
I'm at a loss, but open to suggestions or thoughts.
Attach file:
IMG_3398.JPG (185.25 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=237598