Re: Torsion Level System

Posted by HH56 On 2021/10/8 19:19:59

I can't tell where yours is from the photo but essentially with the tool, the top of the load arm is about even with the small ledge in the frame that the tool end rests on. It usually takes a bit of extra weight on the front to push down and lower the front end which raises the load arm to a position where the tool can be installed. After that the front end is jacked up so the A arms drop and rest on the top rebound bumper. That should give enough room to insert a pin even a bit longer than the 4 groove.

Attach file:

---

  tool.jpg (66.45 KB)