Re: 56 lower A arm bushings
Posted by R H On 2022/2/16 17:38:27
Ross.
Here is what I came up with.
Tail piece for drain. 1-1/2 OD.
I have a brass one 20 ga. Fits snug on bushing.
Went to HD. And got a regulator tail piece.
Its thin. But works.
From flange of bushing. To end of spacer. Just a little over 5/8s inch . which is same as Packard bushings.
No. Not pressed in yet.
Those raise bumps. The spacer rests against those. And will not no into A arm.
.
Attach file:
20220216_143127.jpg (192.46 KB)
Here is what I came up with.
Tail piece for drain. 1-1/2 OD.
I have a brass one 20 ga. Fits snug on bushing.
Went to HD. And got a regulator tail piece.
Its thin. But works.
From flange of bushing. To end of spacer. Just a little over 5/8s inch . which is same as Packard bushings.
No. Not pressed in yet.
Those raise bumps. The spacer rests against those. And will not no into A arm.
.
Attach file:
20220216_143127.jpg (192.46 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=241169