Re: Another Torsion Level (TL) Question

Posted by Marty or Marston On 2022/8/14 21:23:58

Problem solved. The issue occurred while I was troubleshooting a TL problem that was traced to the limit switch. During the testing, the levers on the CLB were move back and forth by using the shorting procedure on the TL Controller on terminals A & B. I noticed that the lever on the right side was no longer engaged with the CLB after a good limit switch was installed. Because the levers were moved back and forth the lever on the right side was out of position. The shorting procedure was used to determine what flat on CLB the lever should go on. Once this was done, t lever was installed and all is working fine now.

Thank You Riki and Howard for your thoughts and inputs.