Re: Vent Window Nylon Repro Project

Posted by humanpotatohybrid On 2022/12/13 19:06:56
Will be shipping orders ASAP.

One note on installation is to be sure to test the fitment in the metal bracket before installation. Depending on the tolerance stack up of both pieces, it may be loose or tight. With the ends of the bracket touching, it should be fairly stiff but turn by hand. If it's loose, remove the piece then with 2 pair of small pliers, hold the L part of the bracket, and the loop part, and bend slightly to adjust that angle. A slightly stiff fit is no cause for adjustment as the piece should break-in slightly with use.

Attach file:

jpg  20221213_175244.jpg (1,584.79 KB)
225076_639913a0c4adf.jpg 4032X3024 px

This Post was from: