stop light switch 56 pat

Posted by Bowman Davis on 2007/10/23 20:07:43
Need some help with 56 pat stop light switch. The switch has three male blades. looking down at the terms,The center term (12v purple wire) and the right term (LT green T/L sw)are N/C contacts and become N/O when the brake is applied, this kills power to T/L as it should. But the brake light does not come on and there is no power at the left term where the DK green wire is terminated. Shouldn't the left term and center terminal have a contact that makes(closes) when the brake is applied. Otherwise I don't see how the brake light could work. according to the wiring diagrams there is no other switch anywhere in the circuit, other than the turn signal flasher.

This Post was from: