Re: Torsion Level System And Other Electrical Misteries

Posted by HH56 On 2010/9/18 10:22:20

If the dangling light had a metal hood or casing over the lamp, then that is the ign switch light. It is held by slots on an arm attached to ign switch with open side of bulb pointing into a small piece of plastic and almost touching the back of dash. Insert it by squeezing the sides of metal casing slightly together and pushing tabs at bottom of casing into the slots. It can sometimes be a bit stubborn and if not inserted completely or casing is bent and loose, it will fall out.

There are also lights at each side of dash where the air vent levers and heater controls are. These are sockets which are on a long stalk or clip but bulbs are bare glass. The bulb goes into a hole between the levers and the clip slides onto the sides of the housing the levers mount to to hold in position.