Re: Engine Bay detailing on a '56 dual carb car

Posted by Victor On 2015/1/19 21:50:38

Sorry for so much questions but, when I amplify the pic the shows the shields, it seems to me that the small shield that helps cover the choke would be held with one screw only, probably on the tab formed by the cut and bent 'ear' that is formed and through which surely a hole is drilled. If I am correct, the tab could be held by one of the upper carburetor screws (the one in the corner closest to the choke, near the center of the pic)... or is it held also by one of the larger nuts on the carb base (the one closest)?

Either a pic or a good description or measurements would help a lot!

The pic is this carburetor area I am referring to...

Attach file:

---

  (94.33 KB)