Re: Engine Bay detailing on a '56 dual carb car
Posted by Victor On 2015/3/4 21:21:30
Yes, Howard, you are right. Mine is different, so it was probably made. And comming to analize it a bit I don't see the reason for the spring in that rod. I will take good look tomorrow, and also at the possibility of moving the one spring to where it should be.
In the meantime, these are the clamps I am referring to. I already know what the larger one is for... the heater hose on the front of the block... one looks like it was soldered to something and might have been the oil entrance tube in the transmission, I will take a look. but the other two small ones, the ones with rubber, any ideas where they are supposed to go?
Attach file:
(63.11 KB)
In the meantime, these are the clamps I am referring to. I already know what the larger one is for... the heater hose on the front of the block... one looks like it was soldered to something and might have been the oil entrance tube in the transmission, I will take a look. but the other two small ones, the ones with rubber, any ideas where they are supposed to go?
Attach file:
(63.11 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=158520