Re: Engine Bay detailing on a '56 dual carb car
Posted by HH56 On 2015/3/4 21:42:31
Have to think on the 2 remaining clamps. The soldered one has been identified, the bottom is clean and small so looks like it might be for a section of wiring but where is the question. The other one also looks small like it too might be for wiring but can't place where it would get that dirty or spattered unless it is under and part of TL harness. I'll look thru some photos and see if there are likely places to check unless someone else comes up with a ready answer.
On the rubber piece, Joel is packards1 who frequents this forum. You can PM him or email packards1@AOL.com. Mike Dulinski doesn't do much via email so phone is best. Here is his info.
Attach file:
(10.34 KB)
On the rubber piece, Joel is packards1 who frequents this forum. You can PM him or email packards1@AOL.com. Mike Dulinski doesn't do much via email so phone is best. Here is his info.
Attach file:
(10.34 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=158529