Re: Engine Bay detailing on a '56 dual carb car
Posted by HH56 On 2010/10/31 21:39:31
The ign wire brackets were a fairly late change
https://www.packardinfo.com/xoops/html/downloads/SC/SC-VOL30NO3.pdf The hose clamps should be the wire type and there are some vendors selling kits of the correct ones. Some on here have bought them and can point you their direction. Just make sure the hoses you use with them are not the cheaper smaller diameter type sometimes found in parts stores now or the tension might not be sufficient.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=63228