Re: Engine Bay detailing on a '56 dual carb car
Posted by BigKev On 2010/11/4 16:33:57
I'm sure someone could easily make something like this (pic below). All you would need to do is drill a larger hole where the vent is in the existing MC lid. Tap it, and install the fittings, and then run a line up to the bottom of a vessel of some kind with a vented lid.
Then of course make a bracket for it.
Attach file:
(6.01 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=63519