Re: Installing pusher fan?

Posted by Owen_Dyneto On 2011/3/18 12:21:37

As described a few posts back, here's a cooling system flushing gun that was pretty much a standard tool of the auto service shop of the era for flushing cooling systems in the car. Water and compressed air inlets are obvious; on the outlet side the brass fitting is in place because the last time it was used was for a heater core. Otherwise you just slide it up over the lower radiator hose to get a proper fit.

If you see one at a flea market, I advise picking it up. They often go for as little as $5. Very good addition to the old car owner's tool box.

Attach file:

---

  (199.43 KB)