Re: 374 with Dual Intake Manifold Question

Posted by ssaeger On 2011/8/4 14:41:04

Jack..thanks for the information. I am not worried about an original appearance at all on these, just looking for something that will fit the bolt pattern on the manifold. I took the gasket that came off the manifold to Jegs to look at a carburetor but it didnt fit the gasket (the manifold gasket off the intake was narrower than what I looked at). The carburetors I looked at are designed for a dual 4 barrel set up, but as I said the bolt pattern on them were too large.

I dont have any carburetors for this engine so I dont have anything to have rebuilt so I am stuck looking for something to place on the engine.

Steve