Eaton pump lid bolt seal
Posted by Cli55er On 2012/2/24 11:08:38
about to start rebuilding my power steering pump in my 55 and i don't see the funnel shapped seal for the bolt that goes through the lid in the kit from Max. i see an extra o-ring....so i guess i could just use a washer and put the o-ring under that, but has anyone sourced the funnel shapped seal that goes on there.
there is no individual Packard part number for that seal. but there is a bolt, a washer, and then a funnel type seal that holds the lid on the power steering pump
i have searched all mighty google to no avail. maybe i don't know the right terminology for that seal so my results are not coming up.
then again maybe i'm wrong and it is just an o-ring. but it seems like, iirc, when prying my old on off that it had a funnel bottom that fit into the hole of the lid and then the flat part at the top.
Hank
Attach file:
(8.55 KB)
there is no individual Packard part number for that seal. but there is a bolt, a washer, and then a funnel type seal that holds the lid on the power steering pump
i have searched all mighty google to no avail. maybe i don't know the right terminology for that seal so my results are not coming up.
then again maybe i'm wrong and it is just an o-ring. but it seems like, iirc, when prying my old on off that it had a funnel bottom that fit into the hole of the lid and then the flat part at the top.
Hank
Attach file:
(8.55 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=95450