Re: ultramatic

Posted by R H On 2012/4/15 13:39:59

morning mcmaster.com..thanks,,i have a caged needle bearing,, J-2316..,,which i plan to use, 2 inch bore, which is a few thousandths larger than std, shaft.

the od, is 2-3/8s. width 1 inch. l was going to use it but od was too big,

but since i can take out packards casting,,,and make my own,, will use it..

might get new shaft...

thanks,,

rik

ps....if i knew of this site,,before i got into this, it would of made things easier...

thanks...