Re: 55-56 batwing air cleaner
Posted by BH On 2012/4/18 18:46:45
Attached is a pic of K-D's Carburetor and Distributor Adjuster #2201, which includes TWO bits and a turning knob.
The flat-bladed bit is recessed in a tube to help stabilize the blade on the screw. An allen hex bit, with short piece of flex cable, is used to adjust ignition points through the window of the cap - as used on distributors beginning 1957, IIRC.
Note the red dots on either end; there's a silver dot on the opposite side. These serve as an aid for counting the number of turns.
Built with 1/4" square drive, this tool might just come in handy, with other sockets, for other situations.
Attach file:
(54.90 KB)
The flat-bladed bit is recessed in a tube to help stabilize the blade on the screw. An allen hex bit, with short piece of flex cable, is used to adjust ignition points through the window of the cap - as used on distributors beginning 1957, IIRC.
Note the red dots on either end; there's a silver dot on the opposite side. These serve as an aid for counting the number of turns.
Built with 1/4" square drive, this tool might just come in handy, with other sockets, for other situations.
Attach file:
(54.90 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=99455