Re: 56 400 starter problems

Posted by HH56 On 2012/6/17 9:36:27

Blown fuse could be the result of a problem in the actuator, no?

It could which is why I suggested the "unpressed" condition so nothing gets power past the two button feed busses & actuator would essentially be dead. Would consider the actuator as a last resort because in an earlier post he said it had been overhauled and had all new wiring. Would hope it was a good job and is still good and nothing was pinched putting it back in.

Think we should rule out the pressure switch circuit first since it's a known failure item. Maybe a wire pulled out of terminal & shorted or switch itself somehow shorted.