Re: Torsion Level Problem

Posted by R H On 2012/6/22 15:39:03

The rear axle ones are easy,, all you need is a jack, turn off system.

never done the uppers,, but they need it.. need to hold load arm up.. to get support arm off..

also ,,,you can use 1955 lower bushings, leave off metal bracket or cup(bushing fits in), put bushing right on support arm..

the 55 bushing is rectangle larger surface area, did it with a 56 clipper,,,torsion worked great..

mine went up and down...looked at axle,,,,what bushings,,,

they were gone,,NOS,, i would get newer stuff,,,i make my own out of durathan. my dad made molds.. round and rectangle (55)

its a slow process,,,one at a time.

your next question should be , what is the torque for axle bushings.