Door Gaskets

Posted by Jim McDermaid On 2012/10/8 14:01:55

When I bought my 54 Cavalier about a year ago it came with some spare parts in the trunk.

There were two boxes containing the door gaskets which I installed over this past weekend, one on the driver's door and one on the back.

The gaskets are attached to the actual door and are glued in place. I used 3M black trim and gasket glue which held them on nicely. I picked the worst two doors as that is all the gaskets I had.

I know some of the gaskets are available from the parts venders in complete sets which I haven't gotten into yet.

Each of the four doors have a more specialized gasket that is attached to the door pillar that seals the front of each door, don't know if you can buy these.

The old gasket on the driver's door had a metal strip imbedded in the bottom side which had tabs up into the bottom of the door. The rear door did not. I suppose the metal strip will never be in reproduction gasket material. I also sealed the rubber seal for the wing windows.

My goal was to get rid of water leaks which eventually get onto the inside door panels and leave stains.

The new gaskets make the doors a little harder to close and I wonder if any of you have had the experience and how long before the new gaskets finally compress a little.

I will also say a bunch of rattles have disappeared like magic.

Jim