Re: Heater hose connections
Posted by HH56 On 2013/2/5 11:16:04
I'm assuming my 47 to be original routing and if so, water starts at the shutoff valve in middle of head to top tube of dash heater. Out of lower tube from dash heater to a bend over type retainer on frame and then thru the space between frame and floor to a clamp. Drops down to another clamp on the metal part of frame under the trans & across to the underseat heater.
Return follows exactly the same path and the clamps are shared until the frame in engine compartment where there is another bend over type retainer and then on to water pump.
Here are some not too good pictures of my probably never to be reassembled car. What I cannot tell without getting dirty is if there is a second clamp under the trans on drivers side just before the heater. Don't see any bolts on that side but feels like there may be something on top.
Attach file:
(27.98 KB)
(42.19 KB)
(38.22 KB)
(28.75 KB)
(23.12 KB)
(20.96 KB)
(33.05 KB)
(74.46 KB)
Return follows exactly the same path and the clamps are shared until the frame in engine compartment where there is another bend over type retainer and then on to water pump.
Here are some not too good pictures of my probably never to be reassembled car. What I cannot tell without getting dirty is if there is a second clamp under the trans on drivers side just before the heater. Don't see any bolts on that side but feels like there may be something on top.
Attach file:
(27.98 KB)
(42.19 KB)
(38.22 KB) (28.75 KB)
(23.12 KB)
(20.96 KB)
(33.05 KB) (74.46 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=117085