Re: Prewar AC info

Posted by PackardV8 On 2013/4/27 20:15:00
If the bracket can be mounted 1" higher than oem design then maybe use COUPLER nuts on the studs. Place bracket ontop of coupler nuts and install bolts thru bracket threading into upper end of coupler nut.

Note that oem probably specs for a hardened steel washer between nut and head. Since the bracket bolt is screwed into the coupler nut that will lock it so the washer can be deleted I'd rather use the washer but if necessary for hood clearence etc then leave it off.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=121867