Re: WDO-531 carb base gasket question
Posted by HH56 On 2014/5/7 11:22:57
This is the gasket that was on mine between the carb and insulator block on intake manifold. Same carb as yours. Looks to be some kind of heat resistant material and approx 3/32" thick. Daytona rebuilt my carb and sent the exact same type gasket back.
The vacuum is internal but on your carb do you not have a small maybe 3/16" hole located in a raised part of the iron casting below and slightly to the rear of the throttle shaft? It is on the side of bottom flange similar to the one in photo above. Believe that hole provides the air for the vacuum to draw the ball up.
Attach file:
(85.16 KB)
The vacuum is internal but on your carb do you not have a small maybe 3/16" hole located in a raised part of the iron casting below and slightly to the rear of the throttle shaft? It is on the side of bottom flange similar to the one in photo above. Believe that hole provides the air for the vacuum to draw the ball up.
Attach file:
(85.16 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=143827