Re: Put tubes in them tires?

Posted by BigKev On 2014/7/14 11:36:51

I only wanted to do these once, and not have to worry about them for a long....long time. So I primed them with two coats of epoxy DTM primer (same as I used on the car). Then are a scotch brite pad scuffing and wipedown, I then sprayed them with PPG Single Stage Urethane. I basically painted the wheels like the car with the color to match. If the outside of your wheels are already painted, and you are just asking about the inside, then I would imagine POR-15 or similar paint would be good, and help to ward off rust and smooth out any pits. Just make sure it goes on evenly so you don't have any wheel out of balance issues. So spraying would be better than hand brushing in that regards. Just me $.02.

Frankly, any good quality direct to metal primer/paint would be than what was used or not used by the factory. If you need something quick and easy, then even Rustoleum Rusty metal primer/paint would work.