Re: 1949 Standard ignition switch

Posted by Deskdriver On 2014/9/11 22:37:18

Must have short, the ignition checked out fine with the ohm meter. Double, triple checked my tagged wires and the terminals. Installed the back on the ignition and nothing. Before I started messing with it, it fired up and I drove it home.

The wires to the carb, starter, distributor and generator have all been changed to new wire (Should say newer wire, plastic coated). So this is going to be a challenge.

I have downloaded the schematic from this website and printed it. So I think I'm all set, except for the chiropractors appointment when finished.

Thank you all for writing and don't stop either. Everyone has been helpful.

B.