Re: Ammeter

Posted by Jimmyk On 2024/5/20 12:23:34

Ok thanks…I just did a continuity test with and I’m getting continuity between the two terminals…I don’t know if that’s bad or good….I ran wires from both terminals and tested on battery ..there is a little spark at battery but no movement at needle..I can also see a piece of what looks like thin cardboard running from terminal to terminal it’s one piece that is bolted down by both terminal base nuts…I don’t know what that is either…any thoughts? Before I yank it…ok I just got a light on the needle and I believe you are right ..it looks like the needle went over the max stop and not stuck on the other side..I guess I’ll have to remove it…but thanks for the info..I never would have looked that close at the tabs…