Re: First steps? '49 Packard

Posted by Packard Don On 2024/6/25 11:39:12

To confirm what TxGoat said, do not convert to 12v and to add, it is positive ground.

Before trying to start it, I would remove all spark plugs and fill the cylinders with oil and let it set a few days with the plugs screwed back in loosely. This is to be sure there is some lubrication to the upper end before starting. Then, with the plugs out, lay an old towel down the length of the engine to catch the oil, crank with the starter it to push out the excess oil, then put the plugs back in. When it starts, it will smoke a lot so be sure it’s in a well ventilated location!

As far as how much oil, use the engine number and enter it into the Packard Decoder which should pull up basic specifications/