Re: 6v wire harness...replace or repair?
Posted by JD in KC On 2010/10/29 15:52:04
I used a double layer of shrink wrap on the actual soldered splices and ensured the splices were staggered so none were actually next to each other in the bundle.
I removed, cleaned, and re-soldered all the original connectors onto the new wire and finished it off as JW suggests with a short length of shrink wrap over the base of the connector. Re-using the connectors was time consuming but not particularly difficult. Except for the bright colors of the modern wiring, the finished product looks good.
I still keep a fire extinguisher handy in any case.
I removed, cleaned, and re-soldered all the original connectors onto the new wire and finished it off as JW suggests with a short length of shrink wrap over the base of the connector. Re-using the connectors was time consuming but not particularly difficult. Except for the bright colors of the modern wiring, the finished product looks good.
I still keep a fire extinguisher handy in any case.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=63075