I haven't found any with a complete picture of the entire linkage -- just bits and pieces. Vol 24 #4 SC
https://www.packardinfo.com/xoops/html/downloads/SC/SC-VOL24NO4.pdf has the part on side of trans - bellcrank back, and how to adjust. The first volume of the 3 part complete Ultramatic Service Training manual has bits on the side of engine and carb from bellcrank up.
https://www.packardinfo.com/xoops/html/downloads/Ultramatic_part1.pdf It is a large download, so here is a pertinent picture.
Not sure how much help either will be because Packard relied on gauges to set up all the adjustments. So far, I have not found any direct measurements we can use -- just snippets of clearances.
Attach file:
(228.29 KB)![209_4cf3d16bcfd88.jpg 1196X1600 px](https://packardinfo.com/xoops/html/uploads/newbb/thumbs/209_4cf3d16bcfd88.jpg)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=65504