Packard skin grafts
Posted by Ross On 2011/3/20 21:09:26
Finally time to do the paint and bodywork on my 127k mile 56 Super Packup. Being an east coast car I have worked down the side with inner and outer rockers, replacing floor stringers etc. Was a bit stymied by the lower rear quarter which had been pranged in the distant past (repaired with lead), had rusted since, and received another prang by some of my injudicious offroading. Its not so easy to roll a nice curve for those panels, so time for a trick.
Nasty Patty in the backyard was suffering from terminal gangreen but the tops of the rear quarters were of course still good. (Nasty Patty previously donated a miraculously intact trunk floor to the Balboa) Anyway it was amazingly easy with the help of a contour gage and a tape measure to locate a suitable patch panel in the middle of Patty's left rear quarter. Here are the results. Just for reference the top of a 51-53 junior rear quarter will make a wonderful panel for the bottom of any 51-54 rear quarter.
Attach file:
(107.00 KB)
(81.10 KB)
(113.98 KB)
Nasty Patty in the backyard was suffering from terminal gangreen but the tops of the rear quarters were of course still good. (Nasty Patty previously donated a miraculously intact trunk floor to the Balboa) Anyway it was amazingly easy with the help of a contour gage and a tape measure to locate a suitable patch panel in the middle of Patty's left rear quarter. Here are the results. Just for reference the top of a 51-53 junior rear quarter will make a wonderful panel for the bottom of any 51-54 rear quarter.
Attach file:
(107.00 KB)
(81.10 KB)
(113.98 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=72732