Unknown wire on 47 Super Custom Clipper?

Posted by packard7 On 2011/5/22 0:44:59

I am trying to find out where a loose wire in my 47 Packard super custom 8 goes. The car has the electromatic clutch. There are 3 wires in the loom. Two of them are male push in connectors that go to the Clutch Control valve. The 3rd wire is about 9 inches much longer and has a round wire connector end. It seems to come from the Overdrive control relay. It is not a live wire so I assume it acts a ground for another circuit? Any ideas?