Re: 1932 902 differential

Posted by Tim Cole On 2011/9/19 8:31:28

Dear Curtis:

Yes there is supposed to be a gasket.

However, if you don't want to tear the whole car apart you can try the following stop gap method:

a) drain the differential oil and let unit drip over the a few weeks.

b) using pre-sol, scrapers, rags, etc clean the surfaces methodically.

c) apply a high quality silicone sealer around the joint and let cure over 24 hours.

d) make sure the vent is not clogged.

This might avoid removing the axles, drive shaft, etc etc to replace the gasket.

Good luck