Re: new member needs some repair info
Posted by BDeB On 2012/3/8 2:15:58
Quote:
HH56 is correct
You will need to drop the heater and vent controls and then remove the two special barrel shaped nuts that hold the switch mounting plate to the dash.
Access will be better if you remove the heater plenum and the radio.
Be sure to disconnect the battery as the original wiring will be brittle and the insulation may crack and fall off when you pull the mounting plate off the studs on the dash.
I've attached some photos to show how the mounting plate and switches attach to the dash.
Attach file:
(89.81 KB)
(109.31 KB)
(96.20 KB)
HH56 wrote:
Been a long time and hopefully one of the 22-3 guys will correct me if wrong but I believe the switches are on a support plate held by two screws. I think only the heater vent controls may have to move to access the screws & plate and then the switch assy will drop down.
HH56 is correct
You will need to drop the heater and vent controls and then remove the two special barrel shaped nuts that hold the switch mounting plate to the dash.
Access will be better if you remove the heater plenum and the radio.
Be sure to disconnect the battery as the original wiring will be brittle and the insulation may crack and fall off when you pull the mounting plate off the studs on the dash.
I've attached some photos to show how the mounting plate and switches attach to the dash.
Attach file:
(89.81 KB)
(109.31 KB)
(96.20 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=96321