Re: 928S Carb - Where to get parts?

Posted by Ross On 2014/5/18 21:16:25

That arm is to rotate on the shaft for adjustment so does not have a flat.

Agree with Owen--have never needed to replace a metering rod unless an idiot was in the carb before me. As to your bent jet(?), I am pretty sure Daytona can supply one or you can straighten yours as long as it is not crushed. If the choke housing gasket is missing then I'm sure it is an oversight as their kits are quite complete in my experience. If I recall, some kits have a gasket there, others have just an O-ring to seal the vacuum port at that junction. If you mean the gasket just under the thermostatic coil, some kits have a disc with a slot, and some just have a flat ring gasket. Either one is OK.