1940 160 Super 8 Bell Housing question
Posted by SteveP516 On 2018/11/28 14:11:32
During the dis-assembly of my project, I noticed that someone had previously modified a transmission support to accommodate the transmission mounts.
During my research to determine what was going on, I've noticed that there are different depths to the bell housings.
Mine measures approx, 8" deep and I measured another at about 7.5". This would account for the extra holes drilled in the support bracket.
I've looked for casting/part numbers for identification without much success.
I'm looking for a way to determine what is correct.
Does anyone have any thoughts on this?
Thanks,
Attach file:
(275.50 KB)
During my research to determine what was going on, I've noticed that there are different depths to the bell housings.
Mine measures approx, 8" deep and I measured another at about 7.5". This would account for the extra holes drilled in the support bracket.
I've looked for casting/part numbers for identification without much success.
I'm looking for a way to determine what is correct.
Does anyone have any thoughts on this?
Thanks,
Attach file:
(275.50 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=207723