Re: windshield wipers for 41
Posted by HH56 On 2020/8/22 12:54:17
No clue if the conventional body electric wiper setup differs significantly from the Clipper version used thru 47 but here is some info and photos for the Clipper style.
The blade has a hole that fits down over the shaft and is held by a threaded cylinder with a screwdriver slot on one end. That acts much like a barrel nut and screws onto the shaft pressing the blade down onto the shaft. The cylinder nut is .345 or 11/32 -- just shy of 3/8 long by .235 or 1/64" shy of 1/4 inch. The shaft has serrations on the bottom which slide into the blade hole but I don't see any definitive matching serrations in the blade for them to grab onto. The screwdriver slots on the cylinder nut are flush with the blade housing when assembled.
Attach file:
(82.87 KB)
The blade has a hole that fits down over the shaft and is held by a threaded cylinder with a screwdriver slot on one end. That acts much like a barrel nut and screws onto the shaft pressing the blade down onto the shaft. The cylinder nut is .345 or 11/32 -- just shy of 3/8 long by .235 or 1/64" shy of 1/4 inch. The shaft has serrations on the bottom which slide into the blade hole but I don't see any definitive matching serrations in the blade for them to grab onto. The screwdriver slots on the cylinder nut are flush with the blade housing when assembled.
Attach file:
(82.87 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=225849