Re: 55 Patrician

Posted by BH On 2009/3/15 20:59:45

Howard -

The only plated, die-cast parts I can add, after reviewing your extensive list, would be:

P-A-C-K-A-R-D hood letters

Gold-plated vees on the plastic side roof (crest) emblems

Squarish side trim pieces on C-pillar (that complete the line crated by the stainless moldings at the top and belt of the doors)

Last but not least, the curved pot metal pieces that make the transition from the stainless rocker molding, to the straight, stainless fender skirt molding, and then to the stainless rear gravel shield.

However, interior molding spears are usually stainless. Wheel covers are also stainless, but with a flash coast of chrome, I believe.

Clyde -

I can't recall if the rear window wiper was shown in the accessory catalog or parts book, but since it fit models from previous Series that used the same backlight, I'm not surprised that it was installed on this car.

I agree - sounds like a good project car.