Re: Packard locks and keys
Posted by humanpotatohybrid On 2021/8/11 12:42:53
Quote:
R H wrote:
Picture 3.
If you can remove those pins holding the brass key pins. Then it's easy to make a key.
Key cylinder..
The wafers? I leave them in, insert the key blank, mark around them with a ultra fine point Sharpie so I know where to file (in between the marker marks) and then take the blank out and file the grooves down with a square needle file turned diagonally and test it often to get it exactly right.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=235969