Re: Spark plug seat reconditioning

Posted by JeromeSolberg On 2022/2/4 21:50:18

So: I did a few things:

1) Cleaned those areas really well with a wire brush.

2) Used a bit of JB-weld to fill the pits, smoothed it out using a tool I made from an extra head stud and bolt, which fit down in there real nice.

3) After the JB-weld had cured for 24 hours, used the wire brush again to smooth it out once more. Truthfully, by the time I'd done all this, I'm not sure any of the JB-weld was left, very little if that.

Took the car for a couple hour+ long test drives and see no problems at the spark plugs anymore.

Thanks everyone!