Re: Solid State Voltage Regulator
Posted by Packard Don On 2022/6/23 18:46:17
I've made some headway on my design with a couple prototype printed circuit boards (PCBs) having been made. The unit is comprised of two boards: one shown here which contains the regulator circuitry and another daughter board below it that is not shown which maps the connections to the proper place in the housing. This will allow the regulator to work with different housings and external connection location.
What you see here attached to an assembly support (it makes soldering easier) is incomplete and was just a trial fit but a couple components ended up being larger than expected so a new board is being made.
Attach file:
IMG_2262.jpg (266.56 KB)
IMG_2263.jpg (211.49 KB)
What you see here attached to an assembly support (it makes soldering easier) is incomplete and was just a trial fit but a couple components ended up being larger than expected so a new board is being made.
Attach file:
IMG_2262.jpg (266.56 KB)
IMG_2263.jpg (211.49 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=245187