Re: Engine rebuild, help!

Posted by moodydavid16 On 2022/12/8 13:45:28
Quote:

For a good precise measurement I'd recommend a micrometer rather than a caliper.

I have a micrometer but I am worried about using it on the crankshaft because I don't want to scratch the journals at all. and I also don't have any micrometer that can measure the id of the bearings. what is the tool called that should be used to measure the bearings? I would imagine you would torque down the caps with bearings inside but no crank. Is this the right way to do it?

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=251304