Power loss……🔌
Posted by Doc On 2023/9/8 19:49:36
Hi folks, me again, 🤣
No seriously, were is the fuse bloc located I think I have a blown fuse, the car cut off on the road, starter was able to turn over a few times but the engine didn’t fire up, then it wouldn’t do any more, then I noticed the gages weren’t working, seems a fuse went or an interlock switch is stuck. Going to get the volt meter out and see if I can check continuity across the starter solenoid and a switch on the OD and reverse switches. Wanted to take it out after a wash job, to show it off but was disappointed. No power in circuit being “made”when the key is on.
😞
Check out the Packard Merlin engine wearing this mustang!
Attach file:
IMG_4351.jpeg (467.79 KB)
No seriously, were is the fuse bloc located I think I have a blown fuse, the car cut off on the road, starter was able to turn over a few times but the engine didn’t fire up, then it wouldn’t do any more, then I noticed the gages weren’t working, seems a fuse went or an interlock switch is stuck. Going to get the volt meter out and see if I can check continuity across the starter solenoid and a switch on the OD and reverse switches. Wanted to take it out after a wash job, to show it off but was disappointed. No power in circuit being “made”when the key is on.
😞
Check out the Packard Merlin engine wearing this mustang!
Attach file:
IMG_4351.jpeg (467.79 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=261348