Re: CAUTION ON THE USE OF SILICONE BKAKE FLUID IN ESAMATIC BRAKE SYSTEMS

Posted by PackardV8 On 2007/10/9 12:05:53

"Because it occurs at all wheel cylinders I have determined that it is in the Boost Cylinder. I shall remove it and replace the residual check valve with a NOS ..."

I assume that means that u have to pop ALL FOUR wheel cylinder bleeders to geta release????? If so then u must have BRAKE HOSE problems. With good hoses then popping ANY ONE, EXACTLY ONE, and ONLY ONE bleeder should release ALL of the rest of the cylinders.

I don't care if the hoses are new. Either the hoses are bad or the brakes lines are plugged up. Problem, as u describe is NOT in the master cylinder not the power booster.