Re: Quoting Text

Posted by JWL On 2009/11/10 18:45:05

.quoteSince Kev hasn't put in a "quote" button to reply to posts, you have to copy the text you want, then use [.quote] to start, then [./quote] to finish.
Remove the . in the "quote" section, I did this so you could see it and it wouldn't actually quote anything./.quote

Eric, thanks. Let's see if this works.

By the way there is a guy on the PAC discussion forum looking for info about using 327 crank & rods in a 288 block. I referred him to you, but you may want to help him before he asks.

Edit: Looks like I am close but not quite there.